Mullane School Of Motoring Cork
Reverse to left on Driving test
Reverse to left on Driving test
How to Reverse Around the Corner for The Irish Driving Test – Reversing around the corner allows you to change direction if it’s too narrow to carry out the turn on the road.
There are several ways of carrying out this manoeuvre, which can be discussed with you’ on the day.
STEP 1: Prepare
Preparation, Observation, Manoeuvre Routine.
Learning this skill is vital and enables you demonstrate safe Driving skills.
: Vehicle Control – You need to be able to display good steering techniques throughout, the manoeuvre with smooth clutch, and brake control
TWO: Observation – Checking for near by pedestrians and traffic by carefully looking all around, in front of, and behind you over both shoulders and in your mirrors,
Giving way to all road users and if required selecting first gear and moving back to you’re starting point.
THREE: Positioning – Your ability to keep reasonably close to the kerb maintaining consistent distance as you negotiate the bend.
STEP 2: The Setup
Pull over to the left just before corner you want to reverse around selecting first gear, checking mirrors, signal your intention to move out, and looking over you’re right shoulder for any other road users that may be approaching (This area is known as you’re Blindspot area).
If it’s clear, move out slightly and move forward passed the junction, looking at the side roads as you pass.
This will allow you to identify any potential hazards preventing you from carrying out the manoeuvre.
Once you’ve passed the side road signal you’re intention to pull in and stop smoothly and safely approximately two car lengths passed the turn and approximately half a meter away from the kerb.
Always apply a handbrake after the vehicle has come to a rest and select neutral gear.
STEP 3: The Reverse
Press the clutch fully down, select reverse gear, and release the clutch slowly and smoothly until you reach a bite point.
You must have 360 degree view around you’re vehicle!
Pay particular attention for pedestrian's and if it’s safe to move off let the handbrake off and keep the vehicle moving at a walking pace using proper clutch control.
Stop if any other road users approach from any direction.
STEP 4: When to Turn
Before moving off check the initial turning point as this is where the straight part of the kerb meets the curve (in some cases).
This may require an adjustment of your left wing mirror. After you’ve completed the manoeuvre make sure to adjust your left wing mirror back to it’s correct position before moving off.
When you’re back wheel comes in line with this point the steering wheel can be gently turned left. The amount you turn would depend on the severity of the curve.
As the front of you’re vehicle starts swinging out it’s vitally important to look over you’re right shoulder for any approaching traffic.
As you enter the new road pay particular attention to the other vehicles that may not realise what you’re doing and drive in behind you.
Keep you’re speed at walking pace to remain in full control.
STEP 5: Straightening Up
As you’re now entering the new road glance out of the left wing mirror to check if the distance from the rear tyre to the kerb measures approximately half a meter.
At this point slightly counter steer right until the wheels are straight and continue back into the road until the tester tells you to stop.
Don’t forget that you must still remain highly vigilant at this time around the corner.
Then you can clutch down, brake to a stop, apply handbrake and select neutral gear.
Once again ensure that you’re not blocking any driveways or causing any obstruction.
With plenty of practice you too will have enough confidence to carry out the manoeuvre successfully.
. If you’ve any further questions for me please feel free to contact me i would be delighted to hear from you.